Installation
BEFORE YOU START: Be certain to use appropriate personal protection equipment such as leather gloves, safety glasses, etc., and avoid all possible pinch points and possible sharp edges as you install the agri-TRAC.
Provide clearance between the wheel and the tower structure for the agri-TRAC by either reversing the wheel (Valley and some T-L wheels) or by installing the agri-TRAC Spacer between the wheel and the gearbox.
With the wheel still jacked up about 3 inches, slide a preassembled pair of agri-TRAC sections under the tire. This is easily done by pulling the track with rope or wire. You can also do this step by running the tire over the track. Be certain that the treads in the track point the same direction as the tire treads on the bottom of the tire. The tire treads bars must mesh with the agri-TRAC treads.
Connect the other two pair of preassembled track sections to both ends of the section under the tire. Tighten the nuts to approximately 100 ft/lbs torque. Wrap the track around the tire. Lower the tire 2 inches. Install the remaining bolts nuts and bushings.
Lower the tire so that the tread bars mesh inside the track treads. Check for proper inflation.
After running the agri-TRAC for a few days check tightness of all hinge bolts and wheel lug bolts.



